Parker Parflex Hose 518C
Non-Conductive Hose
SAE J517 ANSI A92.2

Meets or Exceeds SAE 100R7
1000-3000 PSI

Tube: Polyester
Reinforcement: Fiber
Cover: Proprietary Blend (PFX)
Cover Color: Orange, non-perforated
Temperature Range: -40°F to +212°F*; -40°C to +100°C*
*Limited to +135°F (+57°C) for synthetic hydraulic fluids and
water-based fluids.
Vacuum Rating: N/A
(Delta) Working Length @ Rated WPSI: +2% Max
Applications/Markets: Medium pressure hydraulic service
where both field attachable and permanent hydraulic circuit
exposure and contact with high voltage may be encountered
Special Features: Twin or multi-line constructions available
Meets SAE J517 for less than 50 micro-amps leakage under
75,000 volts per ft. Meets or exceeds SAE 100R7 specifi cations
and Ontario Hydro electrical standards

Complies with ANSI A92.2 for vehicle-mounted aerial devices.
High density braid for maximum impulse life without loss
of flexibility

Note: Lay lines on this hose will have both ANSI and SAE
maximum working pressures listed. ANSI A92.2-1990 "Vehicle
Mounted Elevating and Rotating Aerial Devices."

** 3/16" and 1/4" working pressure reduced to 3,000 and 2,750
respectively when using fi eld attachable (51 series) couplings.

Min. Burst Pressure:
4:1 Design Factor is required if hose failure will result in
movement of aerial device.

3:1 Design Factor is acceptable if hose failure will not result in
movement of aerial device.

SAE requires 4:1 Design Factor.
N/A = Not Available

* 51 series fi eld attachable couplings are not intended for use
on hose that has previously been in service.

Did this page answer your questions about Parker Parflex hose 518C?
What other info would you find helpful?

Valley Belting & Hose distributes Parker Parflex hose 518C
throughout Ohio, Indiana and Kentucky.

HOME | PARKER HYDAULIC HOSES | NEXT HYDRAULIC HOSE | CONTACT